What Clean Brush after applyingPledge Floor Wax??

[Warren]

Gentlemen,

What does one use to clean brush after applying Johnsons Pledge (Klear) Floor wax? Mineral Spirits, Alcohol or Acetone?

Thanks.

Warren

[Paul]

I use Ultimate modelling products cleaner, cleans the stuff out of there no problem

[Vleugelmoer]

Ultimate cleaner, or if you don't have that water and IPA Isopropyl Alcohol work fine as well.

As always happy modeling and keep sticking styrene.

The other Paul

[Warren]

Thanks. I found another cleaner, Windex, because it contains ammonia. The Floor wax instructions suggests using ammonia plus water to remove the wax. Windex contains ammonia so it should do the clean up.

Thanks.
Warren

[Paul]

Thanks. I found another cleaner, Windex, because it contains ammonia. The Floor wax instructions suggests using ammonia plus water to remove the wax. Windex contains ammonia so it should do the clean up.

Thanks.
Warren

Where are you located warren (can you fill in your location in your profile please to save this question, if your in the uk, windex no longer contains ammonia.

[wookiee76]

Airbrush i use water and then some Ultimate to get the last bits out, paintbrush just a quick swill in some water. As long as you don't let it dry it comes out easily.

[Warren]

Paul,
I am located near the Atlantic Ocean in New Jersey USA. Sorry for the delay I have been away over three months from model hobbying due to a severe pinched nerve in my lower back.

Warren

[digger303]

ammonia is the stuff you need.....should be able to buy cloudy ammonia on it's own.
And yes take a minute to fill in your location...it makes answering questions that much easier.....you can all see how helpful it could be...