PE to clear parts help

[gaz45]

Before fitting the canopy on my build there is some PE to fix on the canopy

20171018_115737 by Gary Wilcox, on Flickr

My question is how do you attach the PE to the clear parts without them fogging up

[ElCapitan]

I use Micro Krystal Klear, but should be ok with most PVA glues that dry clear. Just a small amount should do it.

[TheNordus]

I would use PVA too, and then not even breathe near it for the fear of it falling off.

[Twokidsnosleep]

Yep..white glue my friend

[shortCummins]

[youtube]OAuEjVbie-o[/youtube]

[gaz45]

Thanks guys for your help

[Vindicare]

where can you get that uv glue in europe?

[tytax]

I glue tiny PE part with Future. I think it could work with a canopy as well.

[Augustus]

where can you get that uv glue in europe?

I bought the el cheapo stuff on eBay just to try. Although I wouldn't use it to fix a table leg etc it might work well for this. I don't know if it was just the cheap stuff I bought or not but it took quite a while, relatively, for it to work not the 10 seconds or whatever that's advertised.
But as I say it may work well for very small stuff.

[digger303]

where can you get that uv glue in europe?

I bought the el cheapo stuff on eBay just to try. Although I wouldn't use it to fix a table leg etc it might work well for this. I don't know if it was just the cheap stuff I bought or not but it took quite a while, relatively, for it to work not the 10 seconds or whatever that's advertised.
But as I say it may work well for very small stuff.

I did the same and was disappointed. I wondered wether or not the supplied uv light was actually on the right bandwidth cause it didn't cure at all. I tossed it.