Photo etch wipers

[Richo]

Hi

I recently purchased a set of ABER 24012 - 1:24 Wipers. I have absolutely no idea how they actually attach to the car as their is no pin on the wipers that I can use to attach them to a drilled hole in the car. Anyone used these before? Any tips?

[Twokidsnosleep]

Looks like you might need to put a little pin on the car itself and connect to the hole on the arm
I can't post pics from my work computer, but will try to help more later.

[Richo]

20240306_101919.jpg

20240306_101825.jpg

20240306_101825.jpg

The top one is the view from the bottom
The next two from the top
The last from the side

[Johnj]

I'm just thinking out loud here but does the plastic kit wiper fit 'inside' the PE folds ?

[Richo]

No they attach to the other end

[Tommy124]

Hi there,

if I'm not mistaken, the product instructions indicate that the PE wipers be located on or below the windscreen, without any fixation points.
You can view the instructions here, bottom image.

https://www.modellversium.de/kit/artikel.php?id=3507

[Johnj]

No they attach to the other end

Sorry, i meant only the bottom part with the pin to locate it to the car. ?

[Richo]

I'm just thinking out loud here but does the plastic kit wiper fit 'inside' the PE folds ?

No it doesn't

[Richo]

Hi there,

if I'm not mistaken, the product instructions indicate that the PE wipers be located on or below the windscreen, without any fixation points.
You can view the instructions here, bottom image.

https://www.modellversium.de/kit/artikel.php?id=3507

Thanks Tommy, yes I have the instructions. It looks as though I will have to straddle the PE wipers on the bottom frame of the windscreen? This will mean when I install the front windscreen that it won't fit flush on the frame unless I sand out a nook for the wipers to sit into?

[Tommy124]

Hi there,

if I'm not mistaken, the product instructions indicate that the PE wipers be located on or below the windscreen, without any fixation points.
You can view the instructions here, bottom image.

https://www.modellversium.de/kit/artikel.php?id=3507

Thanks Tommy, yes I have the instructions. It looks as though I will have to straddle the PE wipers on the bottom frame of the windscreen? This will mean when I install the front windscreen that it won't fit flush on the frame unless I sand out a nook for the wipers to sit into?

Yes Richo, it would appear to be so. I would suggest to add a (very) small piece of thin plastic rod to the bottom of the PE parts, as a vertical connection point, and in order to balance out the height of the windscreen frame...