Stug III F Reveal

[TexasAndy]

Hey guys I have finally finished the CyberHobby Stug III Ausf. F

Please check out the video;

[youtube]BA0YH6eroSM[/youtube]

[Panzerwolf]

Nicely done!
The StuG looks very good, I particularly like the chipping.
With some figures it would fit into a diorama nicely!

[TexasAndy]

Thanks I am glad you liked it!

[LocoFeldwebel]

Very nice build. I have the same kit on my bench now and am stumped by the PE heat shield for the rear exhausts. I cannot seem to get it to fit on the angle between the tow fittings. Any advice would be appreciated.

[TexasAndy]

Very nice build. I have the same kit on my bench now and am stumped by the PE heat shield for the rear exhausts. I cannot seem to get it to fit on the angle between the tow fittings. Any advice would be appreciated.

I wish I had some super secret technique to give you bud but I'm sorry I don't. This part was a bit fiddly but after 3-4 tries I got it to wedge between the idler housing and the exhaust. It wasn't perfect and in fact it is "bowed" slightly but I got it on. If it gives you fits I usually back off and watch TV or something and then go at it again after 30 minutes or so.

[Schoof]

WOW she's looking gooooooood !! Well done! !!

[localjedi]

Looks great! How about a little diorama for it?

[Gav0909]

Moved to the correct place for you mate.