Cocktail Stick

[Donkeywalloper]

Hi all

Stupid little question but one I need to ask.
I notice the heavy use of Cocktail Sticks to mount pieces of model on prior or during painting.
How do you attach the model piece to stick?
Thanks muchly

[MikeyKb]

Super Glue, or 'CA'
Or you could use a small amount of blue-tak.

Hope that helps!

[Donkeywalloper]

Many thanks Mikey

[Paul]

I use any holes or gaps i can poke the stick through, or cut the end of the stick flat and using a very small amount of ca glue glue the stick in a place that wont be seen, this then snaps off cleanly once done.

[Donkeywalloper]

I use any holes or gaps i can poke the stick through, or cut the end of the stick flat and using a very small amount of ca glue glue the stick in a place that wont be seen, this then snaps off cleanly once done.

Thanks Paul.

[Paul]

I use any holes or gaps i can poke the stick through, or cut the end of the stick flat and using a very small amount of ca glue glue the stick in a place that wont be seen, this then snaps off cleanly once done.

Thanks Paul.

Just started to use the uv activated glue to attach parts to sticks it works brilliantly and comes of clean too

[fly1ngdutchm4n]

I driil a small hole in the figures heel.
Then glue the toothpick with superglue in it.
if the figure is sitting, I drill a hole in his a..hole