Williams Renault FW 19

[Twokidsnosleep]

Thank you Scott for directing me to this complete stage by stage build, I have just spent a very enjoyable couple of hours reading and learning from this thread,

The amount of detail you have added is outstanding, can I ask, have you used 3M glazing putty for all the filling?

My absolute pleasure Alan

Yes, I tend to use that automotive 3M putty for my filling, unless final paint is really light though the paint will still likely cover
I also do a painted layer of CA glue over the putty before a final sanding to seal any little pits or air bubbles and it hardens the putty even more
Always happy to help mate, feel free to ask questions

[Loki17]

Scott

I just started my build yesterday and came across your thread. I will thank you in advance for doing all the research for me. I had this kit laying around for a long time and finally decide to build it.Yes this kit is terrible for detail and molds are sad. You did an amazing job on your build knowing how aweful this kit is.

[Twokidsnosleep]

Scott

I just started my build yesterday and came across your thread. I will thank you in advance for doing all the research for me. I had this kit laying around for a long time and finally decide to build it.Yes this kit is terrible for detail and molds are sad. You did an amazing job on your build knowing how aweful this kit is.

Thanks
It turns into a gorgeous car with a bit of effort
Just hit me up if you need anything

[Loki17]

Sure, should have some questions. I decided I did not like the look of the rear drive so I am adding aluminum driveshaft.

[Loki17]

_DSC3414.JPG

[Loki17]

more photos