Global Scale Modeller

Hi guys. Question here.

I just received Bronco's new 1-35 scale StuG III Ausf. E kit in the post. It comes with, along with a few other goodies , a set of individual link workable tracks. There are 17 sprues of track links (204 links) and several hundred tiny connector pins. I would firmly like not to screw up when I build these tracks, but it looks to be a daunting task.

Have any of you built Bronco workable tracks before? Any tips/tricks/issues to be avoided?

Any information would be helpful

I did build a set of M1A2 tracks and they were... complicated but turned out excellent... they are basically a kit on their own !

looking at the instructions on your kit !

http://www.armorama.com/modules.php?op= ... t&id=12484

They are more simple than mine but... But those end pins are super fine !
Just cut off the sprues what you need and keep your work tight !
Assemble small sections of tracks ( about the size of the jig ) to which you will join others sub assemblies later on just to keep the work manageable ! That way you run less risks of damaging a long track....

good luck !