Global Scale Modeller

I am building the Eduard Danger Zone F14 limited edition and I have come to the part of the resin exhausts.
Now the instructions are straight forward

20171013_130754 by Gary Wilcox, on Flickr

However looking at the parts of resin in my kit they differ from those that i have seen in other reviews of this kit

My parts

20171013_130730 by Gary Wilcox, on Flickr

Parts from other reviews

eduard1192reviewmd_13 by Gary Wilcox, on Flickr

Mine seam to be in 1 piece
So do i need to cut these parts where i have indicated and turn them around and glue them together to get the right desired finish

20171013_130730 by Gary Wilcox, on Flickr

I hope I have explained this well enough

I don't think so. Based on the picture you provided from the "other" source. The perspective makes it a little difficult, but as far as I can tell your parts match. There are just some pieces missing.

YA I see what you mean.
The flared portion accepts the PE and then the tube attaches to it....yours are cast as one long piece
Withought being there to touch it, I think you are on the right track with cutting at the seam and turning things around for assembly

Looks like you should have some photo etched parts as well, any other parts laying around that are extra?

You should contact Eduard Customer Support to clarify, they are very good.

Thanks guys
I will do that