1/72 Leopard 2A7v W.I.P.
Posted: Sat Nov 03, 2018 4:33 am
Hello all!
I'm working on this small side project as a distraction from college duties. I was wondering if anyone had any suggestions for how I could improve/go forward from this point? It's a Revell Leopard 2A6/A6M; while I scratch built most panels with sheet styrene and 3D-printed the bustle and rear-right hull machinery.
Happy Modelling!
I'm working on this small side project as a distraction from college duties. I was wondering if anyone had any suggestions for how I could improve/go forward from this point? It's a Revell Leopard 2A6/A6M; while I scratch built most panels with sheet styrene and 3D-printed the bustle and rear-right hull machinery.
Happy Modelling!