Global Scale Modeller

Started this as a test build to try out some techniques before I have a go at a WNW kit. The kit is far from easy to get together with very vague locating pins for the fuselage half's, wings, struts and landing gear. But after some struggle it all went together. I used Uschi van der Rosten wood decals for the fuselage, the engine, exhaust, spinner, mg barrels and turnbuckles where all 3d printed and the propeller was cnc milled from a piece of 4mm birch plywood. Made a small base for it and added a pilot from PJ productions and a mechanic from Aerobonus.

That is brilliant! Propeller is a nice touch

Well I can’t wait for the wingnut wings work if this was just a tester to get you ‘eye in’. Awesome work sir

Can only agree with the comment above I would have gone straight for the WnW build with that sort of result . The Eduard WW1 kits are notoriuosly a pain to build and with that sort of result your going to breeze through a WnW kit.

Thanks a lot for the comments guys!

Superb build, the attention to detail is amazing

If I could pinch it I would and claim it as mine
except everyone would know better

That's just stunning work Jon!

Absolutely beautiful. Well done sir.

Absolutly stunning.
the bar is set for that WNW.

grtz Arjan