Global Scale Modeller

"WHAT HAVE YOU BEEN WORKING ON THIS WEEK?" - A NEW SEGMENT OF FRIDAY NIGHT'S ISM LIVE "AT THE BENCH" SHOW!

* Open now until 1 hour before the show on Friday, 23rd September*

** PLEASE read ALL of the rules below carefully! **

Hello everyone! This post is being created to give you, as a member of ISM, the opportunity to share what you have been working on during the week on the Friday night show. Please read the rules below in order to participate.

01). By participating in this thread, you are giving permission for the ISM live crew to share your work during the Youtube broadcast of the ISM Live "At the Bench" Friday show.

02). Please, only post your own work and not that of others.

03). Remember, post only one image per member each week. This will prevent prolific builders from dominating this segment and will prevent this part of the show from becoming too long.

04). Also, have only one project shown in the image per member each week. Again, this prevents prolific builders from dominating this segment and making this segment longer than it needs to be.

This is an opportunity for you as members to be directly involved with the show. We hope that you will participate no matter your level of experience. This will not be a critique of anyone's work.

The winner will have their model displayed on the Paul@ism live stream header

We thank you in advance for allowing us the opportunity to showcase your models!
Paul and the live crew

Evenin young Dan!

Following on from Lancelot (thanks for all the positive comments ) I seem to have rekindled my figure painting mojo...

Next out of the stash is a 75mm Banshee by White Werewolf Tavern which has been 3d printed by El Greco Miniatures.

Painting so far has been done with Ultimate Primers, followed by paint & washes by Vallejo, Andrea, Games Workshop & Mig.

Good Evening All

Working on this Tamiya 1/24 Jagermeister Porsche this week, chassis and interior are done apart from seatbelts. Progress on the body has been slow, whilst the thick decals should never show any bleed through from the orange they are a bit of a job to blend into the clear coat.

Thanks for looking.

Hi the ISM team.

I'm still working (and it's really a pain in the ass) on the Su-25 K from OEZ. Each part has to be sanded, revised, tested, again and again and again ... so time consuming and so boring.
I almost use all the modeler's tools (except the hammer but there wouldn't have been a picture! ) for this kit, Tamiya putty and Mr. Surfacer are very useful too.
With this kind of kit a 3D printer isn't an option, it seems to be easier to create the full kit in resin!



Take care of yourself and relatives, see you on the live!