Page 1 of 1
Stug III F Reveal
Posted: Fri Jan 17, 2014 8:20 pm
by TexasAndy
Hey guys I have finally finished the CyberHobby Stug III Ausf. F
Please check out the video;
[youtube]BA0YH6eroSM[/youtube]
Re: Stug III F Reveal
Posted: Fri Jan 17, 2014 9:10 pm
by Panzerwolf
Nicely done!
The StuG looks very good, I particularly like the chipping.
With some figures it would fit into a diorama nicely!
Re: Stug III F Reveal
Posted: Fri Jan 17, 2014 10:26 pm
by TexasAndy
Thanks I am glad you liked it!
Re: Stug III F Reveal
Posted: Wed Feb 12, 2014 3:03 am
by LocoFeldwebel
Very nice build. I have the same kit on my bench now and am stumped by the PE heat shield for the rear exhausts. I cannot seem to get it to fit on the angle between the tow fittings. Any advice would be appreciated.
Re: Stug III F Reveal
Posted: Wed Feb 12, 2014 12:51 pm
by TexasAndy
LocoFeldwebel wrote:Very nice build. I have the same kit on my bench now and am stumped by the PE heat shield for the rear exhausts. I cannot seem to get it to fit on the angle between the tow fittings. Any advice would be appreciated.
I wish I had some super secret technique to give you bud but I'm sorry I don't. This part was a bit fiddly but after 3-4 tries I got it to wedge between the idler housing and the exhaust. It wasn't perfect and in fact it is "bowed" slightly but I got it on. If it gives you fits I usually back off and watch TV or something and then go at it again after 30 minutes or so.
Re: Stug III F Reveal
Posted: Wed Feb 12, 2014 2:22 pm
by Schoof
WOW she's looking gooooooood !! Well done! !!
Re: Stug III F Reveal
Posted: Thu Feb 13, 2014 7:44 am
by localjedi
Looks great!
How about a little diorama for it?
Re: Stug III F Reveal
Posted: Thu Feb 13, 2014 1:04 pm
by Gav0909
Moved to the correct place for you mate.