Global Scale Modeller

I put the top engine cowl on. The fit is pretty good except for the part of the panel line that is closest to the cockpit. There is a slight step between the cowl piece and the cowl the was molded with the fuselage. I know that I am going to have to do some sanding. The problem is, there are very fine circles indicating the panel screws and I know I am going to sand them off. Any suggestions?

I am going to use Alclad II, so my prep work has to be pretty spot on.

Thanks

Use micro drill bits in a pin vice and when you have nearly removed screw mark deepen the hole with the drill. Don't go too mad though you can always do a bit more once your done. They may not be identical to the original mark but once you have paint and a wash in them you will never notice.

My main concerns was the difference in appearance. Thanks SCraven for easing my mind. The step is not too bad. However, it will stick out like a sore thumb when I paint it with Alclad II.

Would it be possible to remove plastic from inside the panel, thereby making it thinner, allowing it to sit lower/flush with the fuselage?

That is definitely an option, Chief.

After working on the seam step a bit, I have smoothed off the edges. However, in trying to keep as much of the surface detail on the high side, I still have the step, but it has a smooth feel to it. I know it will show up if I shoot it with some primer. I guess my only option is to take off more material on the high side, which means all of the rivets and panel lines will be sanded off.

Damn! That's a shame. Good luck with the rest of it!