Matchbox 1/72 Provost Mk.1
Posted: Sun Aug 10, 2014 3:05 pm
Another has one that has been sitting around for a couple of years; not a bid kit, and one that Matchbox had not re-released often over the years, so I was very happy to pick this one up for $1.00 at a show. I think I put it away because the bottom seam on the fuselage kept popping open. Typical matchbox kit, decent enough and with a little work will polish up nicely.
I added a bit of side wall detail to the cockpit, and extended the cockpit floor as it ended just in front of the seats, and you could see right down to the bottom of the fuselage

And all painted up

Seat belts are masking tape painted up, I was going to replace them with some etched ones I have gotten since, but they look decent, so I might just leave them as is.
And all together, where I left it.

I added a bit of side wall detail to the cockpit, and extended the cockpit floor as it ended just in front of the seats, and you could see right down to the bottom of the fuselage

And all painted up

Seat belts are masking tape painted up, I was going to replace them with some etched ones I have gotten since, but they look decent, so I might just leave them as is.
And all together, where I left it.
