Page 1 of 1
How to on panel lines
Posted: Sun Jun 14, 2015 4:41 am
by Coen
This is how I do panel lines using clay based washes and oil based washes.
[youtube]8ffGlDY359c[/youtube]
Re: How to on panel lines
Posted: Sun Oct 18, 2015 8:38 pm
by Lee1979
Hi great video what thinner did u use to remove the enamel wash thanks
Re: How to on panel lines
Posted: Mon Oct 19, 2015 2:21 am
by Coen
I never use "enamel" washes, but oil washes are almost identical for what we use them for. I always use Weber's Turpenoid. I buy it at my local arts and crafts store.
Re: How to on panel lines
Posted: Mon Oct 19, 2015 4:12 am
by Twokidsnosleep
Great video
Asking a dumb question: what happens if you leave the washes on for longer than 20 min?? Like a day or longer
ie the longer you leave it, the harder to remove??
Re: How to on panel lines
Posted: Mon Oct 19, 2015 9:53 am
by Coen
Nothing happens with the clay based washes, you can remove them anytime, unless you seal them in with a varnish. The. You're screwed.
Oils/enamels you should not leave longer than a few hours or they'll start to cure and then you'll have a problem.
Re: How to on panel lines
Posted: Mon Oct 19, 2015 4:52 pm
by Twokidsnosleep
Ok thanks
I have only used oils and freak out a bit when I apply them so probably remove a bit too quickly, but then my auto/plane subjects tend to be less weathered than armour builds so it works out ok.