Part 1.
Ok, found a subject so time to start my first build.
Not gone tell you what it's going to be, see if you can guess...
______________________________________________________________________________
______________________________________________________________________________
I started by opening the sprue bag, to see what's inside.
1 egg, 2 eggs, 3 eggs...... ok, bunch off eggs...
And, wait.... no decals and no instructions... This is going to be a challenge...
So, I looked up some pics on the internet and got on with it.
First step was, I cut it in half.
And closed up one piece with some styrene.
Then I cut a cirkel out of some 0.5mm styrene.
And used the hole as a guide for cutting of the top.
Makes it much easier to make a straight cut, and, off course, you can use the cut out as a lid.
The marker is there, because I needed the cap...
And I needed it for this..
Added a ring from the spares box.
Then I made some supports from, again, some styrene.
Can you guess what it is yet? No?
Ok, I'll add a litle more detail first.
A plate with some pipes.
Which goes here.
And a bracket over it.
And some bigger pipes.
And, yes you have guest it, some more pipes and something of a electric box.
Sorry, it all sits a bit crooked. That's because most off it is not glued on yet.
And this is what I got done up to now, next time some more difficult steps...
______________________________________________________________________________
______________________________________________________________________________
Thanks for looking.
Comments? Yes please, good and bad.
Peter.
, my uhm... kit... finally came in..
